Dell Inspiron B120 - Manual (Page 88)

88
Adding and Replacing Parts
NOTICE:
If you need to install memory modules in two connectors, install a memory module in the connector
labeled “DIMMA” before you install a module in the connector labeled “DIMMB.” Insert memory modules at a
45-degree angle to avoid damaging the connector.
NOTE:
If the memory module is not installed properly, the computer may not boot properly. No error message
indicates this failure.
5 Ground yourself and install the new memory module:
a Align the notch in the module edge connector with the tab in the connector slot.
b Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it
clicks into place. If you do not feel the click, remove the module and reinstall it.
1 memory module 2 securing clips (2 per
connector)
1
2
book.book Page 88 Thursday, September 22, 2005 8:08 AM