Dell PowerVault MD3000 - Manual (Page 2)

2 When HyperTerminal prompts for a name, type
MD3000 or MD3000i and
click OK. Select the COM1 port and click OK.
3 Set the following communication settings, click Apply, then click OK.
Bits per second: 115200
Data bits: 8
Parity: none
Stop bits: 1
Flow control: none
LINUX Operating System
The following instructions use the Linux application, MINICOM, to connect via
the serial port:
1 Open a terminal/command window.
2 At the prompt, type
minicom (all lowercase) and press <Enter>.
3 Once MINICOM is open, press <Ctrl><A>, then <Z>, then the letter
<O> to open the configuration screen.
4 Select Serial Port Setup and press <Enter>.
5 Press <F> to change Hardware Flow Control setting to
no .
6 Press <E> to set the Comm Parameters.
7 Press <I> to set the
speed to 115200 .
8
P ress <Q> to set the data , parity , and stopbits to 8-N-1 ,
then press <Enter>.
9 Press <Enter> to exit the Comm Parameters screen.
10 Select Exit and press <Enter> again to exit the setup screen.
Reset Password
The procedure you should use to reset the password depends on whether your
RAID controller is running first-generation firmware (version 06.
xx.xx.xx) or
second-generation firmware (version 07. xx.xx.xx).
52933A00.fm Page 10 Thursday, March 19, 2009 9:56 AM