Removing memory, Installing memory – Dell OptiPlex 320 User Manual
Page 73
the operating system.
Removing Memory
1.
Follow the procedures in
Before You Begin
.
2.
Carefully press out the securing clip at each end of the memory module connector.
3.
Remove the memory module.
To install memory, see
.
4.
Replace the computer cover (see
Replacing the Computer Cover
).
Installing Memory
1.
Follow the procedures in
Before You Begin
.
2.
Press out the securing clip at each end of the memory module connector.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that
you may have, even if you purchased the new modules from Dell. If possible, do not pair an original memory module with a new memory module.
Otherwise, your computer may not start properly.
NOTE:
Memory purchased from Dell is covered under your computer warranty.
1 memory module
2 securing clip (2)
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
NOTE:
Memory purchased from Dell is covered under your computer warranty.
1 connector
2 securing clips (2)
3 memory connector closer to processor