Printing photos from a, Pictbridge-enabled camera, Printing photos from a pictbridge-enabled camera – Dell V305 All In One Inkjet Printer User Manual
Page 45
The Print dialog box opens.
4. Click Preferences, Properties, Options, or Setup (depending on the program or operating system).
The Printing Preferences dialog box opens.
5. On the Print Setup tab, select Photo, and then select the dpi settings for the photo from the drop-down menu.
NOTE:
To print borderless photos, click the Borderless check box on the Print Setup tab, and then select
the borderless paper size from the drop-down menu on the Advanced tab. Borderless printing is only
performed if you are using photo/glossy paper. The printout on non-photo paper contains a 2 mm margin on
all sides.
6. On the Print Setup and Advanced tabs, make any necessary changes for your document.
7. When you finish customizing your settings, click OK.
The Printing Preferences dialog box closes.
8. Click OK or Print.
9. Remove each photo after it exits the printer to prevent your photos from sticking together or smudging.
Printing Photos From a PictBridge-Enabled Camera
Your printer supports printing from a PictBridge-enabled camera.
1. Turn on your printer.
2. Insert one end of the USB cable into the camera.
3. Insert the other end of the USB cable into the PictBridge port on the front of the printer.
See the instructions included with your camera for selection of the appropriate camera USB settings and PictBridge
connection and usage information.
NOTE:
When your printer is not connected to a computer, and a PictBridge camera is connected to your
printer, some of the functions of your printer operator panel buttons may be unavailable. These functions
become available after you disconnect the PictBridge camera from your printer.
4. Turn on your digital camera.
The printer automatically enters PictBridge mode.
5. See the instructions included with your camera to begin printing photos.
NOTE:
Before placing your prints in a nonadhesive photo album or frame, allow sufficient time for the prints to dry
thoroughly (12 to 24 hours, depending on ambient conditions). This maximizes the life of your prints.
NOTICE:
Do not remove the PictBridge-enabled device or touch the printer near the area of the memory card
or PictBridge-enabled device while actively printing from PictBridge. Data corruption can occur.