Display bezel, Replacing the display assembly, Removing the display bezel – Dell Inspiron 15 (M5010, Early 2010) User Manual
Page 19
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.
3.
Route the display cable into the routing guide and connect the cable to the connector on the system board.
4.
Connect the Mini-Card antenna cables to the connectors on the Mini- Card.
5.
Turn the computer over and replace the two screws at the bottom of the computer.
6.
Replace the palm rest (see
Replacing the Palm Rest
).
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the optical drive (see
Replacing the Optical Drive
).
9.
Replace memory module(s) (see
Replacing the Memory Module(s)
).
10.
Replace the base cover (see
Replacing the Base Cover
).
11.
Replace the battery (see
Replacing the Battery
).
Display Bezel
Removing the Display Bezel
1.
Follow the instructions in
Before You Begin
.
1
screws (4)
2
display cable
3
Mini-Card antenna cables
4
display assembly
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.