Replacing the vga connector board – Dell Inspiron 15 (M5010, Early 2010) User Manual
Page 51
Replacing the VGA Connector Board
1.
Follow the instructions in
Before You Begin
.
2.
Place the VGA connector board along with the cable on the computer base and press the VGA connector board until it is seated fully.
3.
Route the VGA connector board cable into the routing guide and connect the cable to the connector on the system board.
4.
Replace the middle cover (see
Replacing the Middle Cover
).
5.
Replace the display assembly (see
Replacing the Display Assembly
).
6.
Replace the palm rest (see
Replacing the Palm Rest
).
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the optical drive (see
Replacing the Optical Drive
).
9.
Replace memory module(s) (see
Replacing the Memory Module(s)
).
10.
Replace the base cover (see
Replacing the Base Cover
).
11.
Replace the battery (see
Replacing the Battery
).
Back to Contents Page
3 system board connector
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.