Dell Latitude E4310 (Mid 2010) - Manual (Page 18)

Back to Contents Page
Display Closure Sensor
Dell Latitude E4310 Service Manual
Removing the Display Closure Sensor
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the battery .
3. Remove the ExpressCard .
4. Remove the hard drive assembly .
5. Remove the hinge covers .
6. Remove the mini card door .
7. Remove the LED covers .
8. Remove the keyboard .
9. Remove the display assembly .
10. Remove the palm rest .
11. Remove the screw that secures the display closure sensor to the computer.
12. Lift up and turn over the display closure sensor.
13. Disconnect the cable from the display closure sensor and remove it from the computer.
Replacing the Display Closure Sensor
To replace the display closure sensor, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.