Dell Latitude E4310 (Mid 2010) - Manual (Page 22)

Back to Contents Page
I/O Board
Dell Latitude E4310 Service Manual
Removing the I/O Board
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the battery .
3. Remove the SIM .
4. Remove the ExpressCard .
5. Remove the SD memory card .
6. Remove the hard drive assembly .
7. Remove the hinge covers .
8. Remove the mini card door .
9. Remove the wireless local area network (WLAN) card .
10. Remove the memory door .
11. Remove the memory .
12. Remove the coin-cell battery .
13. Remove the optical drive .
14. Remove the LED covers .
15. Remove the keyboard .
16. Remove the display assembly .
17. Remove the palm rest .
18. Remove the system board .
19. Remove the screws that secures the I/O board to the computer.
20. Lift up the left side of the I/O board.
21. Gently push the RJ-45 port from outside to release the I/O board and remove the I/O board from the computer.
Replacing the I/O Board
To replace the I/O board, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.