Palm rest, Removing the palm rest, Replacing the palm rest – Dell Latitude E4310 (Mid 2010) User Manual
Page 32
Back to Contents Page
Palm Rest
Dell Latitude E4310 Service Manual
Removing the Palm Rest
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
battery
.
3.
Remove the
ExpressCard
.
4.
Remove the
hard drive assembly
.
5.
Remove the
hinge covers
.
6.
Remove the
mini card door
.
7.
Remove the
LED covers
.
8.
Remove the
keyboard
.
9.
Remove the
display assembly
.
10.
Remove the screws that secure the palm rest to the bottom of the computer.
11.
Flip the computer over and remove the screws that secure the palm rest to the computer.
12.
Disconnect the touch pad, Bluetooth, ExpressCard, volume controls board, and power button cables from their connectors on the system board.
13.
Using a plastic scribe, release the snaps from both the sides of the palm rest.
14.
Push the palm rest forward and remove it from the base.
Replacing the Palm Rest
To replace the palm rest, perform the above steps in reverse order.
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.