Dell U2711 Monitor - Manual (Page 6)

Monitor Specifications
The following sections give you information about the various power management modes and pin assignments for various connectors for your monitor.
Power Management Modes
If you have VESA's DPMS compliance display card or software installed in your computer, the monitor automatically reduces its power consumption when not in
use. This is referred to as Power Save Mode. If input from keyboard, mouse or other input devices is detected by the computer, the monitor will automatically
"wake up". The following table shows the power consumption and signaling of this automatic power-saving feature:
Activate the computer and wake up the monitor to gain access to the OSD .
Pin Assignments
VGA Connector
1 AC power cord connector
2 DC power connector for Dell™ Soundbar
3 Audio out (rear)
4 Audio out (SUB/CTR)
5 Audio out (front)
6 DisplayPort connector
7 DVI connector-1
8 DVI connector-2
9 VGA connector
10 HDMI connector
11 Composite video connector
12 Component video connectors
13 USB upstream port
14 USB downstream ports
VESA Modes Horizontal
Sync
Vertical Sync Video Power
Indicator
Power Consumption
Normal operation Active Active Active Blue 138 W (maximum)*
113 W (normal)**
Active-off mode Inactive Inactive Blanked Amber Less than 2 W
Switch off - - - Off Less than 1 W
* With Audio and USB
** Without Audio and USB
NOTE: This monitor is TCO '03 power management compatible.
NOTE: Zero power consumption in OFF mode can only be achieved by disconnecting the main cable from the
monitor.
Pin
Number 15-pin Side of the
Connected Signal Cable
1 Video-Red
2 Video-Green
3 Video-Blue
4 GND
5 Self-test
6 GND-R