Dell Inspiron 1320 (Mid 2009) - Manual (Page 19)

11. Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from the routing guides.
12. Lift the display assembly off the computer.
Replacing the Display Assembly
1. Place the display assembly in position and replace the six screws (three on each side) of the display assembly.
2. Route the Mini-Card antenna cables through the routing guides.
3. Connect the display cable and the camera cable to their respective system board connectors.
4. Replace the palm rest (see Replacing the Palm Rest ).
5. Replace the hard drive (see Replacing the Hard Drive ).
6. Replace the keyboard (see Replacing the Keyboard ).
7. Replace the center control cover (see Replacing the Center Control Cover ).
8. Connect the antenna cables to the Mini-Card.
9. Replace the module cover (see Replacing the Module Cover ).
10. Replace the battery (see Replacing the Battery ).
Hinge Caps
Removing the Hinge Caps
1. Follow the instructions in Before You Begin .
1 screws (6) 2 display cable connector
3 camera cable connector
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.