Dell Inspiron 1320 (Mid 2009) - Manual (Page 2)

Back to Contents Page
Battery Latch Assembly
Dell™ Inspiron™ 1320 Service Manual
Removing the Battery Latch Assembly
Replacing the Battery Latch Assembly
Removing the Battery Latch Assembly
1. Follow the instructions in Before You Begin .
2. Remove the system board (see Removing the System Board ).
3. Press and push the battery release latch clip to release it from the battery latch assembly.
4. Remove the spring from the hook that holds it in place.
5. Lift the battery latch assembly out of the computer base.
Replacing the Battery Latch Assembly
1. Place the battery latch assembly in the channel in the computer base.
2. Push the battery release latch clip into the battery latch assembly.
3. Using a small screwdriver, place the spring over the hook on the computer base.
Ensure that the newly installed latch moves smoothly and freely when pushed and released.
4. Replace the system board (see Replacing the System Board ).
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery ) before working inside the
computer.
1 battery latch assembly 2 battery release latch clip
3 spring