Drive panels – Dell Precision T7400 (Late 2007) User Manual
Page 246
246
Adding and Replacing Parts
14 Connect the computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on
installing any software required for drive operation.
15 If the drive you just installed is the primary drive, insert bootable disc into
drive A.
16 Turn on the computer.
17 Enter system setup, and update the appropriate Drive option (see "System
18 Exit system setup, and reboot the computer.
19 Partition and logically format your drive before you proceed to the next
step.
20 See the documentation for your operating system for instructions.
Drive Panels
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions located in the
Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
Removing the Drive Panel
1 Follow the procedures in "Before You Begin" on page 139.
CAUTION:
Your computer is heavy (it has an approximate minimum weight of 55
lbs) and can be difficult to maneuver. Seek assistance before attempting to lift,
move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid
injury; avoid bending over while lifting. See your
Product Information Guide for
other important safety information.
CAUTION:
The computer stand should be installed at all times to ensure
maximum system stability. Failure to install the stand could result in the computer
tipping over, potentially resulting in bodily injury or damage to the computer.
2 Remove the
computer cover (see "Removing the Computer Cover" on
3 Grasp the sliding plate lever and push it towards the base of the computer
until the drive panel snaps open.