Installing the power-switch cable, Removing the input/output (i/o) panel – Dell OptiPlex 9010 (Mid 2012) User Manual
Page 23
Advertising
4.
Press in the retention clips and slide the power-switch cable out through the front of the computer.
Installing the Power-Switch Cable
1.
Slide the power-switch cable in through the front of the computer.
2.
Secure the power-switch cable to the chassis.
3.
Thread the power-switch cable into the chassis clip.
4.
Connect the power-switch cable to the system board.
5.
Install the:
a. drive cage
b. front bezel
c. cover
6.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Input/Output (I/O) Panel
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a. cover
b. front bezel
c. drive cage
3.
Disconnect and un-thread the I/O panel/ FlyWire cable from the fan-shelter clip and heat sink.
23
Advertising