Installing the input/output (i/o) panel, Removing the power supply – Dell OptiPlex 9010 (Mid 2012) User Manual
Page 24
4.
Remove the screw that secures the I/O panel to the chassis. Then, slide the I/O panel to the right to release and
remove from the computer.
Installing the Input/Output (I/O) Panel
1.
Insert the I/O panel into the slot on the chassis front.
2.
Slide the I/O panel towards the left of the computer to secure to the chassis.
3.
Tighten the screw to secure the I/O panel to the chassis.
4.
Connect the I/O panel/FlyWire cable to the system board.
5.
Thread the I/O panel/ FlyWire cable into the fan-shelter clip and the routing on the heat sink.
6.
Install the:
a. drive cage
b. front bezel
c. cover
7.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Power Supply
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a. cover
24