Dell KVM 1081AD/ KVM 2161AD - Manual (Page 82)

74 xxx | OBWI Operation xxx
If the target device is currently in use, you may be able to gain access by forcing
a connection to the device if your preemption level is equal to or higher than
the current user's.
To switch to the active session from the local UI (local users only):
1 From the side navigation bar, select Local Session.
2 Select the Resume Active Session checkbox. The Video Viewer window will
appear.
NOTE: The Dell RAK is required for KVM remote access.
NOTE: From the Active Sessions screen, you can view a list of active sessions. The
following information is listed about each session: Target Device, Owner, Remote
Host, Duration, and Type.
General Sessions Settings
To configure general session settings:
1 From the side navigation bar, select Sessions - General. The General
Session Settings screen appears.
2 Select or deselect the Enable Inactivity Timeout checkbox.
3 In the Inactivity Timeout field, enter the amount of inactive time you want
to pass before the session closes (from 1 to 90 minutes).
4 In the Login Timeout field, enter the amount of inactive time you want to
pass before you must log in again (from 21 to 120 seconds).
5 Select or deselect the Enable Preemption Timeout checkbox.
6 In the Preemption Timeout field, enter the amount of time (from 1 to 120
seconds) that a prompt will be displayed to inform you that your session is
going to be preempted.
7 Select the applicable session sharing options (Enabled, Automatic,
Exclusive, or Stealth).
8 Select the Input Control Timeout from 1 to 50, with 1 representing one
tenth of a second.