Dell PowerEdge C410x - Manual (Page 101)

Troubleshooting Your System | 101
Checking iPass Connector to Host System
1. Check the Board to Board (BTB) connectors to the iPass Boards.
2. Check System SMBus device routing table.
Check if iPass Board (GS-IPASS2 / GS-IPASS3) is installed properly
1. See Replacing iPass Board on page 40 for instructions to accessing the iPass boards.
2. Reverse the steps above to reassemble the system.
3. Restart system and test again.
IPASS TOP IPASS Bottom
iPass 1: Slot 1/15
iPass 2: Slot 3/13
iPass 3: Slot 5/11
iPass 4: Slot 7/9
iPass 5: Slot 2/16
iPass 6: Slot 4/14
iPass 7: Slot 6/12
iPass 8: Slot 8/10