Dell Vostro 220s (Late 2008) - Manual (Page 21)

Troubleshooting
21
Error Messages
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
If the error message is not listed, see the documentation for the operating
system or the program that was running when the message appeared.
A FILENAME CANNOT CONTAIN ANY OF THE FOLLOWING CHARACTERS : \ / : * ? “ <
> | — Do not use these characters in filenames.
A REQUIRED . D L L FILE WAS NOT FOUND — The program that you are trying to open
is missing an essential file. To remove and then reinstall the program:
Windows XP:
1 Click Start → Control Panel→ Add or Remove Programs→ Programs and Features.
2 Select the program you want to remove.
3 Click Uninstall.
4 See the program documentation for installation instructions.
Windows Vista:
1 Click Start → Control Panel→ Programs→ Programs and Features.
2 Select the program you want to remove.
3 Click Uninstall.
4 See the program documentation for installation instructions.
drive letter :\ IS NOT ACCESSIBLE . T HE DEVICE IS NOT READY — The drive
cannot read the disk. Insert a disk into the drive and try again.
I NSERT BOOTABLE MEDIA — Insert a bootable CD or DVD.
N OT ENOUGH MEMORY OR RESOURCES . C LOSE SOME PROGRAMS AND TRY
AGAIN — Close all windows and open the program that you want to use. In some
cases, you may have to restart your computer to restore computer resources. If so, run
the program that you want to use first.
O PERATING SYSTEM NOT FOUND — Contact Dell (see "Contacting Dell" on
page 137).
IEEE 1394 Device Problems
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.