Dell Vostro 220s (Late 2008) - Manual (Page 91)

I/O Panel
91
Vostro 220s
Replacing the I/O Panel
NOTICE:
Take care not to damage the cable connectors and the cable routing
clip(s) (if present) when sliding the I/O panel into the computer.
1 Route the I/O panel cables into the chassis through the I/O panel opening,
and guide them through the various holes and bays.
2 Slide the I/O panel cables into the cable clip(s) (if present).
3 Replace and tighten the screw that secures the I/O panel.
4 Reconnect the cables to the system board (see "System Board
Components" on page 40).
1 front-panel opening 2 I/O panel and cables
3 screw
3
2
1