Dell PowerEdge SC1430 - Manual (Page 32)

32
Using the System Setup Program
Integrated Devices Screen
Table 2-4 lists the options and descriptions for the information fields that appear on the Integrated
Devices screen.
Table 2-4. Integrated Devices Screen Options
Option Description
Embedded SATA
(Off default) Allows the integrated SATA controller to be set to Off or ATA Mode.
Optional Hard-Disk Drive
Fan Displays Installed if the optional fourth hard-drive carrier fan cable is connected to
the system board connector and is functioning. Otherwise, displays Not Installed.
IDE Controller
(Auto default) Enables the integrated IDE controller. When set to Auto, each channel of the
integrated IDE controller is enabled if IDE devices are attached to the channel.
Diskette Controller
(Auto default) Enables or disables the system's diskette drive controller. When Auto is selected,
the system turns off the controller when necessary to accommodate a controller
card installed in an expansion slot. You can also configure the drive as Read-Only,
or Off. When using the Read-Only setting, the drive cannot be used to write to a
disk.
User Accessible USB Ports
(All Ports On default) Enables or disables the system’s user accessible USB ports. Options are All Ports
On, Only Back Ports On, and All Ports Off.
Embedded Gb NIC1
(Enabled with PXE
default) Enables or disables the system's integrated NIC. Options are Enabled without
PXE, Enabled with PXE, and Disabled. PXE support allows the system to boot
from the network. Changes take effect after the system reboots.
MAC Address Displays the MAC address for the integrated 10/100/1000 NIC. This field does not
have user-selectable settings.
Serial Port 1
(Auto default) Serial port options are COM1, COM3, Auto, and Off.
When the serial port is set to Auto, the integrated port automatically attempts to
use COM1 first, and then COM3. If both addresses are in use, the port is disabled.
If you set the serial port to Auto and add an expansion card with a port configured
to the same designation, the system automatically remaps the integrated port to
the next available port designation that shares the same IRQ setting.
Parallel Port
(378h default) Selects the address for the parallel port. Options are 378h, 278h, 3BCh, and Off.
The system automatically disables the built-in parallel port if an expansion card
containing a parallel port at the same address is detected.
Parallel Port Mode
(PS2 default) Sets the parallel port mode of operation between AT mode and PS/2 mode. In AT
mode, the integrated parallel port can output data only to an attached device. In
PS/2 mode, the built-in parallel port can both input and output data.
book.book Page 32 Monday, June 5, 2006 1:51 PM