Dell PowerEdge SC1430 - Manual (Page 64)

64
Installing System Components
Figure 3-16. Removing or Installing a Diskette Drive
7 If the drive is being permanently removed, install a front drive bezel insert. See "Removing and
Replacing the Front Drive Bezel Insert" on page 47.
8 Replace the front drive bezel. See "Removing and Replacing the Front Drive Bezel" on page 46.
9 Close the system. See "Closing the System" on page 43.
10 Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
Installing a Diskette Drive
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer and protecting against electrostatic
discharge.
1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 43.
1 drive bay sliding plate 2 interface cable 3 power cable
4 DSKT connector
3
4
1
2
book.book Page 64 Monday, June 5, 2006 1:51 PM