Dell XPS 210 - Manual (Page 37)

Solving Problems
37
Error Messages
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
If the error message is not listed, see the documentation for the operating system or the program that
was running when the message appeared.
A FILENAME CANNOT CONTAIN ANY OF THE FOLLOWING CHARACTERS : \ / : * ? “ < > | — Do not
use these characters in filenames.
A REQUIRED . D L L FILE WAS NOT FOUND — The program that you are trying to open is missing an
essential file. To remove and then reinstall the program:
1 Click the Start button, click Control Panel, and then click Add or Remove Programs.
2 Select the program you want to remove.
3 Click the Change or Remove Program icon.
4 See the program documentation for installation instructions.
drive letter :\ IS NOT ACCESSIBLE . T HE DEVICE IS NOT READY — The drive cannot read the disk.
Insert a disk into the drive and try again.
I NSERT BOOTABLE MEDIA — Insert a bootable floppy disk or CD.
NOTE:
This system supports an optional USB floppy drive.
N ON - SYSTEM DISK ERROR — Remove the floppy disk from the drive and restart your computer.
NOTE:
This system supports an optional USB floppy drive.
N OT ENOUGH MEMORY OR RESOURCES . C LOSE SOME PROGRAMS AND TRY AGAIN — Close all
windows and open the program that you want to use. In some cases, you may have to restart your
computer to restore computer resources. If so, run the program that you want to use first.
O PERATING SYSTEM NOT FOUND — Contact Dell (see "Contacting Dell" on page 112).