Dell S520 Projector - Manual (Page 48)

48 Using Your Projector
b Use and button to set the value.
c After the setup is complete, press the button to exit.
3 After the IP Address, Subnet Mask, Gateway, and DNS is set
up, select Store and press
button to store the settings.
4 If you select Store without pressing the Enter button, the
system will keep the original settings.
R ESET —Press to reset wireless configuration.
M
ENU
S
ETTINGS
— Select and press to activate the menu settings. The
menu settings consists of the following options:
M ENU P OSITION —Allows you to change the position of the OSD menu
on the screen.
M ENU T IMEOUT —Allows you to adjust the time for an OSD timeout. By
default, the OSD disappears after 20 seconds of non-activity.
M ENU T RANSPARENCY —Select to change the transparency level of the
OSD background.
P ASSWORD —When Password Protect is enabled, a Password Protect
screen requesting you to enter a password will be displayed when the
power plug is inserted into the electrical output and the power for the
projector is first turned on. By default, this function is disabled. You
can enable this feature by selecting Enabled. If the password has been
set before, key in the password first and select the function. This
password security feature will be activated the next time you turn on
the projector. If you enable this feature, you will be asked to enter the
projector’s password after you turn on the projector:
1 First time password input request: