Dell S300 Projector - Manual (Page 20)

20 Using Your Projector
3
Using Your Projector
Turning Your Projector On
NOTE: Turn on the projector before you turn on the source (computer, DVD
player, etc.). The Power button light blinks blue until pressed.
1 Remove the lens cap.
2 Connect the power cord and appropriate signal cables. For information about
connecting the projector, see "Connecting Your Projector" on page 9.
3 Press the Power button (see "Using the Control Panel" on page 25 to locate the
Power button).
4 Turn on your source (computer, DVD player, etc.).
5 Connect your source to the projector using the appropriate cable. See
"Connecting Your Projector" on page 9 for instructions to connect your source to
the projector.
6 By default, the input source of projector is set to VGA-A. Change the input source
of projector if necessary.
7 If you have multiple sources connected to the projector, press the Source button
on the remote control or control panel to select the desired source. See "Using the
Control Panel" on page 25 and "Using the Remote Control" on page 27 to locate
the Source button.
Turning Your Projector Off
NOTICE: Unplug the projector after properly shutting down as explained in the
following procedure.
1 Press the Power button.
NOTE: The " Press Power Button to Turn off Projector" message will appear
on the screen. The message disappears after 5 seconds or you can press the
Menu button to clear it.
2 Press the Power button again. The cooling fans continue to operate for 120
seconds.