Dell S300 Projector - Manual (Page 41)

Using Your Projector 41
3D D ISPLAY —Select On to start the 3D display function. Default is Off.
NOTE:
1. When you want to create 3D experience, you will need a few other components
including:
a PC/NB with a 120 Hz signal output quad buffered graphics card.
b "Active" 3D glasses with DLP Link™.
c 3D content. See "Note 4".
d 3D Player. (Example: Stereoscopic Player...)
2. Enable the 3D function when it satisfies any of the below-mentioned conditions:
a PC/NB with graphics card, capable of outputting at 120 Hz signal via VGA or
HDMI cable.
b Input a suite of 3D content via Video and S-Video.
3. When projector detects either of the inputs (mentioned above), the enable 3D
display on "SETUP" -> "3D Display" OSD works.
4. Current 3D support time is as indicated:
a VGA/HDMI 1280 x 720 120 Hz
b Composite/S-Video 60 Hz
c Component 480i
5. The recommended VGA signal for NB is Single mode output (Dual mode is not
recommended).
3D Sync Invert—If you see a discrete or overlapping image while wearing
DLP 3D goggles, you may need to execute 'Invert' to get best match of
left/right image sequence to get the correct image. (For DLP 3D goggles)
Network—Select On to activate network function. Press to configure Network
settings.