Removing the memory, Installing the memory – Dell OptiPlex 7010 (Mid 2012) User Manual
Page 14
NOTE: The memory sockets in your computer may be labeled differently depending on the hardware
configuration. For example, A1, A2 or 1,2,3.
•
If the quad-rank memory modules are mixed with single or dual-rank modules, the quad-rank modules must be
installed in the sockets with the white release levers.
•
If memory modules with different speeds are installed, they operate at the speed of the slowest installed memory
modules.
Removing The Memory
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the cover.
3.
Press down on the memory retaining tabs on each side of the memory modules, and lift the memory modules out of
the connectors on the system board.
Installing The Memory
1.
Align the notch on the memory-card with the tab in the system-board connector.
2.
Insert the memory modules into the connectors on the system board. Install the memory in the order of 1 > 2 > 3 > 4.
3.
Press down on the memory modules until the release tabs spring back to secure them in place.
4.
Install the cover.
5.
Follow the procedures in
After Working Inside Your Computer
.
14