Dell Inspiron XPS - Manual (Page 10)

Back to Contents Page
Display Assembly and Display Latch
Dell™ Inspiron™ XPS and Inspiron 9100 Service Manual
Display Bezel
Display Panel
Display Latch
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Turn the computer over and remove the four screws (two on each side) labeled "D" on the bottom of the computer.
3. Turn the computer over and open the display.
4. Remove the left, right, and center hinge covers .
5. Disconnect the antenna cables (pull to separate the connectors).
CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
NOTICE: Before turning the computer over and removing the screws, ensure that the display is firmly latched closed.
1 M2.5 x 6-mm screws labeled "D" (4)