Dell Inspiron XPS - Manual (Page 13)

Display Panel
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Remove the display .
3. Remove the display bezel .
4. Remove the M2 x 3-mm ground screw that attaches the display-panel ground wire to the back display cover.
5. Remove the eight M2 x 3-mm screws from each side of the display panel.
6. Lift the display panel out of the display cover.
1 M2.5 x 6-mm screws (6)
2 rubber display bumpers (6)
3 display bezel
4 M2.5 x 6-mm shoulder screws (2)
5 screw covers (2)
CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.