Dell Studio XPS 435 MT (Late 2008) - Manual (Page 7)

12. Connect the computer and devices to electrical outlets, and then turn them on.
13. To complete the installation, see Configuring Your Computer After Removing or Installing a PCI Express Card .
Replacing the Card Retention Bracket
Replace the screw on the card retention bracket ensuring that:
l The notch in the top of the card or filler bracket fits around the alignment guide.
l The tops of all cards and filler brackets are flush with the alignment bar.
l The guide clamps are aligned with the guide notches.
Configuring Your Computer After Removing or Installing a PCI Express Card
Back to Contents Page
1 alignment guide 2 filler bracket
3 alignment bar 4 card retention bracket
5 guide clamps (2) 6 guide notches (2)
NOTE: For information on location of connectors, see the Setup Guide. For information on installing drivers and software for your card, see the
documentation that shipped with the card.
Installed Removed
Sound
Card 1. Enter system setup (see
System Setup ).
2. Go to Advanced Chipset
Features and select
Onboard Audio
Controller, and then
change the setting to
Disabled.
3. Connect the external
audio devices to the
sound card's connectors.
1. Enter system setup (see
System Setup ).
2. Go to Advanced Chipset
Features and select
Onboard Audio
Controller, and then
change the setting to
Enabled.
3. Connect the external
audio devices to the
computer's back panel
connectors.
Network
Card 1. Enter system setup (see
System Setup ).
2. Go to Advanced Chipset
Features and select
Onboard LAN Controller,
and then change the
setting to Disabled.
3. Connect the network
cable to the network
card's connector.
1. Enter system setup (see
System Setup ).
2. Go to Advanced Chipset
Features and select
Onboard LAN Controller,
and then change the
setting to Enabled.
3. Connect the network
cable to the integrated
network connector.