Dell Dimension 2300 - Manual (Page 33)

Power Problems
Printer Problems
Restart the computer and try to log on to the network again
Check your network settings — Contact your network administrator or the person who set up your network to verify that your network
settings are correct and that the network is functioning.
Check for interrupt request conflicts — See " Resolving Software and Hardware Incompatibilities ."
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual.
Adjust the Power Properties — Your computer may be in standby or hibernate mode. For information on power conservation modes, see
the Tell Me How help file, or search for the keyword standby or hibernate in Windows® Help. To access help files, see " Finding Help
Information ."
If the power light is blinking green — The computer is in standby mode. Press a key on the keyboard or move the mouse to resume normal
operation.
If the power light is off — The computer is either turned off or is not receiving power.
l Ensure that the power cable is firmly inserted into both the power connector on the back of the computer and the electrical outlet.
l If the computer is plugged into a power strip, ensure that the power strip is plugged into an electrical outlet and that the power strip
is turned on.
l Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
l Ensure that the voltage selection switch is set to match the AC power at your location (see the safety instructions in your Owner's
Manual).
l Bypass power protection devices, power strips, and power extension cables to verify that the computer turns on.
l Swap the computer and monitor power cables to determine if the power cable is defective.
l Ensure that the microprocessor power cable is securely connected to the system board .
l Ensure that the power supply cables are securely connected to the system board .
l Remove and then reinstall the memory modules .
l Remove and then reinstall any cards .
l If the problem persists, contact Dell (see "Contacting Dell" in your Owner's Manual for the correct number to call).
Eliminate interference — Electrical appliances on the same circuit or operating near the computer can cause interference. Other causes of
interference are:
l Power extension cables
l Keyboard and mouse extension cables
l Too many devices on a power strip
l Multiple power strips connected to the same electrical outlet
HINT: Dell does not cover the printer's warranty. If you need technical assistance for your printer, call the printer's manufacturer. See the printer
documentation for the correct phone number.
Check the printer documentation — See the printer documentation for setup and troubleshooting information.
Ensure that the printer is turned on —
See the printer documentation for power button information.
Verify the printer cable connections —
l See the printer documentation for cable connection information.
l Ensure that the printer cables are securely connected to the printer and the computer (see "Connecting a Printer" in your Owner's
Manual).
Test the electrical outlet —
Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
Verify that the printer is recognized by Windows® —
1. Click the Start button.
2. Click Control Panel.
3. Click Printers and Other Hardware.
4. Click View installed printers or fax printers.
If the printer is listed, right-click the printer icon.
5. Click Properties, and then select the Ports tab. For a parallel printer, ensure that the Print to the following port(s): setting is LPT1
(Printer Port). For a USB printer, ensure that the Print to the following port(s): setting is USB.
Reinstall the printer driver —