Display, Display assembly, Removing the display assembly – Dell Vostro A90 (Late 2008) User Manual
Page 13
Back to Contents Page
Display
Dell™ Vostro™ A90 Service Manual
Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the module cover (see
Removing the Module Cover
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the palm rest (see
Removing the Palm Rest
).
5.
Turn the computer over, make note of the cable routing, and carefully dislodge the Mini-Card antenna cables from their routing guides.
6.
Pull the Mini-Card antenna cables through the system board as shown in the figure.
7.
Disconnect the display cables and the speaker cable from the respective system board connectors.
8.
Make note of the display cables and the speaker cable routing and carefully dislodge from their routing guides as shown in the figure.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
1
Mini-Card antenna cables