Dell Vostro A90 (Late 2008) - Manual (Page 23)

Back to Contents Page
Wireless Mini-Card
Dell™ Vostro™ A90 Service Manual
Removing the Mini-Card
Replacing the Mini-Card
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer supports one full Mini-Card slot for Wireless Local Area Network (WLAN).
Removing the Mini-Card
1. Follow the instructions in Before You Begin .
2. Remove the module cover (see Removing the Module Cover ).
3. Disconnect the antenna cables from the Mini-Card.
4. Release the Mini-Card by removing the securing screws.
5. Lift the Mini-Card out of its system board connector.
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
NOTE: Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
NOTE: Depending on the configuration of the computer when it was sold, the Mini-Card slot may not have a Mini-Card installed.
1 Mini-Card 2 securing screw (2)
3 antenna cable connector (2)