Dell Dimension C521 User Manual
Page 99
Appendix
99
Drives
Diskette Drive
(Internal default)
This option enables or disables the floppy drive. The options are Off, USB, Internal,
and Read Only.
NOTE:
If
USB is selected, ensure that USB Controller setup option under Onboard
Devices is set to
On.
Drive 0: (SATA-0)
(On default)
Identifies and enables and disables the drives attached to the SATA connectors on the
system board and lists the capacities for the hard drives.
Drive 1: (SATA-1)
(On default)
Identifies and enables and disables the drives attached to the SATA connectors on the
system board and lists the capacities for the hard drives.
SMART Reporting
(Off default)
This setting determines whether integrated drive errors are reported or not during
system startup.
Onboard Devices
Integrated NIC
(On default)
Enables or disables the integrated NIC controller. Settings are Off, On, On w/ PXE, or On
w/RPL. When the On w/ PXE or the On w/RPL setting is active, if a boot routine is not
available from the network server, the computer attempts to boot from the next device in the
boot sequence list.
Integrated Audio
(On default)
Enables or disables the onboard audio controller.
USB Controller
(On default)
Enables or disables the internal USB controller. No Boot enables the controller but
disables the ability to boot from a USB device.
NOTE:
Operating systems with USB support will recognize USB floppy drives regardless
of the
No Boot setting.
Rear Dual USB0
(
On
default)
Enables or disables the indicated group of USB ports on the back of the computer.
Rear Dual USB1
(
On
default)
Enables or disables the indicated group of USB ports on the back of the computer.
Front USB
(
On
default)
Enables or disables the indicated group of USB ports on the front of the computer.