Cisco 1700 - Manual (Page 38)

Chapter 2 Installing the Cisco 1700 Router
2-6
Cisco 1700 Router Hardware Installation Guide
78-5405-03
Installing the Cards
Follow these steps to install the card in a Cisco 1700 router:
Step 1 Make sure that the power switch is set to the STANDBY
position (
) and that the power cable is not connected
to the power socket on the rear panel.
Step 2 Loosen the thumbscrews on the WAN interface card-slot
cover on the rear panel, as shown in
Figure 2-2 .
You should be able to loosen the screws using your
fingers; however, if the screws are very tight, you might
need to use a Phillips screwdriver.
Figure 2-2 Removing the WAN Interface Card-Slot Cover
Step 3 Remove the metal plate that covers the card slot.
Step 4 Hold the WAN interface card by the edges on either side
of the card front panel, and line up the card edges with
the guides inside the card slot, as shown in
Figure 2-3 .
12158
WAN interface card slot cover
FDX
LNK 100
WIC 0 OK
WIC1O
K
CONSOLE
AUX
Cisco 1
720
10/100 ETHERN
ET
+5, +12, -12
VDC