Cisco 1700 - Manual (Page 74)

Appendix C Installing and Upgrading Router Memory
C-8
Cisco 1700 Router Hardware Installation Guide
78-5405-03
Step 5 Firmly press the DIMM into the slot until the two DIMM
slot guides on each side of the slot move up and over the
end of the DIMM, as in
Figure C-6 . If the guides do not
move up over the edge of the DIMM, move them with
your hands.
Figure C-6 Installing a DIMM
Closing the Chassis
After installing memory on the motherboard, close the chassis by following these
steps:
Step 1 If you disconnected the fan from the motherboard as
described in the
“Opening the Chassis” section,
reconnect the fan cable to the connector labeled FAN on
the motherboard.
Step 2 Locate the posts that protrude from the inside of the
chassis cover and corresponding openings on the chassis
bottom.
2
2
1
DIMM module
DIMM slot
12611
DIMM slot guides