Cisco XR 12410 - Manual (Page 149)

4-19
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Chapter 4 Troubleshooting the Installation
Troubleshooting the Processor Subsystem
Figure 4-6 PRP-3 LEDs
PRP Auxiliary and Console Ports
The auxiliary and console ports on the PRP are EIA/TIA-232 (also known as
RS-232) asynchronous serial ports connect external devices to monitor and
manage the system.
• Auxiliary port—A (male) plug that provides a data terminal equipment
(DTE) interface. The auxiliary port supports flow control and is often used to
connect a modem, a channel service unit (CSU), or other optional equipment
for Telnet management.
• Console port—A (female) receptacle that provides a data circuit-terminating
equipment (DCE) interface for connecting a console terminal.
PRP Reset Switch
Access to the (soft) reset switch is through a small opening in the PRP front panel
(see
Figure 4-3 ). To press the switch, insert a paper clip or similar small pointed
object into the opening.
Caution The reset switch is not a mechanism for resetting the PRP and reloading the
Cisco IOS XR image. It is intended for software development use only. To prevent
system problems or loss of data, use the reset switch only on the advice of Cisco
service personnel.
ACT SIG ACT SIG
BITS 0
DATA LINK DATA LINK
ETH 1 ETH 0
272388
BITS 1 AUX CONSOLE