Cisco 3200 Series - Manual (Page 32)

2-16
Cisco 3200 Series Router Hardware Upgrade Guide
OL-15983-01
Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure
Card Replacement Process
For a 3-WMIC configuration, connect cables to the wiring card as shown in Figure 2-12 .
Figure 2-14 3-WMIC Configuration
Step 3 Route the 20-pin LED cable over the other cables to secure them, and connect the LED cable to port J5
on the wiring card.
270464
1 2
5
3
4
1 Connect FESMIC 10-pin FE1X cable to
WMIC 3. 2 Connect the FESMIC 10-pin FE2X cable to
WMIC 2.
3 Connect the FESMIC’s 10-pin FE3X cable to
WMIC 1. 4 Connect WMIC 3 24-pin cable to port J3 on
the wiring card.
5 Connect the WMIC 2 24-pin cable to port J2
on the wiring card.