There is no sound, The cd does not play, The remote does not function – Sony CDP-CX57 User Manual

Page 32: The player functions incorrectly, Troubleshooting, Specifications, Additional information

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Additional Information

Troubleshooting

If you experience any of the following difficulties while

using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.

There is no sound.

^Check that the player is connected securely.
^Make sure you operate the amplifier correctly.

The CD does not play.

^There is no CD in a slot ("-NO DISC-"

appears).
Insert a CD.

^Insert the CD with the label side facing right.
^Clean the CD (see page 30).

^Moisture has condensed inside the player. Open

the front cover and leave the player turned on
for about an hour (see page 30).

The remote does not function.

^Remove obstacles in the path of the remote and

the player.

^Point the remote at the remote sensor S on the

player.

^Replace all the batteries in the remote with new

ones if they are weak.

“►Set the CD 1/2/3 switch on the remote

according to the posirion of the COMMAND

MODE selector displayed in the front panel
display (see page 5).

The player functions incorrectly.

^The microcomputer chips may be operating

incorrectly. Disconnect the AC power cord, then
connect it back to the wall outlet to reset the

player.

Specifications

Compact disc player

Laser

Semiconductor laser (X = 780 nm)
Emission duration; continuous

Laser output

Max 44.6 pW
* This output is the value measured at

a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.

Frequency response

2 Hz to 20 kHz ±1 dB

Signal-to-noise ratio

More than 107 dB

Dynamic range

More than 88 dB

Harmonic distortion

Less than 0.013 %

Channel separation

More than 100 dB

Outputs

Jack
type

Maximum Load impedance
output
level

LINE OUT

Phono

jacks

2 V Over 10 kilohms
(at 50 kilohms)

DIGITAL OUT

OpHcal

(OPTICAL)

output

cormector

-18 dBm Wave length; 660 nm

General

Power requirements

Where purchased

Power requirements

USA/Canada

120 V AC, 60 Hz

Australia

240 V AC, 50/60 Hz

UK

220 V - 230 V AC, 50/60 Hz

Other countries

110 V - 120 V or 220 V - 240 V
AC, adjustable, 50/60 Hz

Power consumption

12 W

Dimensions (approx.)
(w/h/d)

When the front cover is closed

430 X 182.5 X 295

mm

(17 x 7

1

/4 x

1

5/8

in.) incl. projecting parts
When the front cover is open

430 X 182.5 X 414

mm

(17x 7 1/4 x

16 3/8 in.) incl. projecting parts

Mass (approx.)

5.5 kg (12 lbs 3 oz)

Supplied accessories

Audio cord

( 2

phono plugs - 2 phono plugs) (1)

Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
CD booklet holder (1) and label (1)

Design and specifications are subject to change without notice.

31

Advertising