Sony KP-61XBR48 - Manual (Page 43)

Operating a cable
box or DSS receiver
You can program the supplied remote commander to
operate a cable box or DSS receiver. Follow the
procedures below to set the manufacturer's code
number to operate it.
CABLE POWER ■
CABLE FUNCTION
CODE SET
axD ^ q 6~ cç )
C ê D ŒD Ci
CD C3D QD Œ) (S
0-0 O O
O CD Q
© © @
© © ©.
© © ®
DSS POWER
-DSS FUNCTION
-TV FUNCTION
-0-9 buttons
-ENTER
-CH
(with the lid open)
1 Turn off the equipment you want to set up
and press FUNCTION of the equipment you
want to set up (CABLE or DSS).
---- FUNCTION-
CABLE DSS
CD CD
2
Press CODE SET, then press 0 - 9 to enter
the manufacturer's code number (see the
chart below) and press ENTER. For
example, to program your remote
comrnander to operate a Zenith cable box,
press CODE SET, 2, 1, 2 and ENTER.
ENTER
3
Press CABLE POWER to turn on a cable box
or DSS POWER when you use a DSS receiver.
----- POWER ------- -
CABLE DSS
CD O
c
4 Use the pojection TV control buttons to
check if your code number works.
For example, to operate a cable box, you can use the
CABLE POWER, JUMP, CH + / - , 0-9 and ENTER
buttons.
To operate a DSS receiver, you can use the DSS
POWER, JUMP, DISPLAY, MENU and 0-9 buttons,
and the joystick.
To operate the projection TV
Press TV FUNCTION. Then use the projection TV
control buttons to control the projection TV.
For more details on operating the cable box or
DSS receiver
Refer to the operating instructions that come with the
equipment.
If the remote commander doesn't work
• First, try repeating the setup procedures using the other codes
listed for your equipment.
• If — after trying all the codes listed for your equipment — you still
cannot get the remote commander to work properly, try the
teaming function described on page
43.
Manufacturer code numbers (cable box)
Manufacturer Code number
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. 1. 201, 202, 203, 204, 205, 206, 207, 208,
218
Oak 227, 228, 229
Panasonic 219, 220, 221
Pioneer 214,215
Scientific Atlanta 209, 210, 211
Tocom 216,217
Zenith 212,213
Manufacturer code numbers (DSS receiver)
Manufacturer Code number
Sony 801
RCA 802
Notes
• If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
• If you enter a new code number, the code number you previously
entered at that setting is erased.
• In some rare cases, vour equipment may use a code that is not
provided with this remote commander and you may not be able to
operate your equipment with the supplied remote commander. In
this case, use the equipment's own remote control unit or use the
learning function (page 43).
• Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code numbers revert to
the factory settings and must be reset.