Sony CFD-550 - Manual (Page 19)

AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
With 3.2-ohm loads, both channels driven from 150-10,000 Hz; rated 2.3 W per channel-
minimum RMS power, with no more than 10 % total harmonic distortion in AC operation.
OfAer Specificatioris
CD player section
System
Laser diode properties
Spindle speed
Error correction
Number of channels
Frequency response
Wow and flutter
Radio section
Frequency range
Antennas
Compact disc digital audio system
Material: CaAIAs
Wave length: 780 nm
Emission duration: Continuous
Power requirements
Power consumption
flattery life
240 V AC, 50 Hz (Australian model)
120 V AC, 60 Hz (Other models)
DC 9 V, 6 size D (R20) batteries
AC20W
For CD radio cassctte-corder.
RW recording Tap* playback CD playback
(This output is the value measured at a distance Sony SUM-1 (NS) approx. 15 h approx. 16 h approx. 8 h
of about 200 mm from the objective lens surface Sony Alkaline AMI approx. 40 h approx. 44 h approx. 20 h
on the optical pick-up block.)
200 r/min (rpm) to 500 r/min (rpm)
ICLV)
Sony Refined Super Strategy
Cross Interleave Reed Solomon Code
2
20-20/)00Hz±2dB
Below measurable limit
FM: 87.6-108 MHz
i\M: 530-1,710 kHz
FM: Telescopic antenna
AM: Built-in ferrite bar antenrva
Dimensions
Mass
Supplied accessories
For remote commander:
approx. 6 months
Approx. 637 X 247 x 206 mm (w/h/d)
(25% X 9/f X 8!4 in.) incl. projecting parts
6.2 kg (13 lb 11 oz) (incl. batteries)
AC power cord (1)
Remote commander (1)
Design and specifications subject to change without notice.
Oystidnaf accessories
Sony DYNAMIC MICROPHONE series
Sony MDR stereo headphone series
Cassette-corder section
Recording system 4-track 2<hannel stereo
Frequency response
TYPE I (normal) cassette:
80-10,000 Hz
General
Speaker
Inputs
Outputs
Power output
(excluding USA model)
Woofen 10 cm dia., 3.2 ohms
cone type
Tweeter 3 cm
Mixing microphone input jack
(minijack):
Sensitivity 2.75 mV
For low impedance microphone
Headphones jack (stereo minijack)
For 16-68 ohms impedance
headphones
Speaker terminals
For supplied 3.2 ohms impedance
speaker
23W + 23W
(at 32 ohms, 10% harmonic distortion in
DC op>eration)
For Your Information
119