Sony HCD-241 - Manual (Page 10)

Playing Back Tapes (on either Deck A or B)
his section describes about a basic playback operation on
ither deck A or B.
POWER
-►ON
1 ^ 3
odi
[[.[It:.
cc
L
XiO.ItT'J
_ _ _I
II
IIT,®
—I - ^.T " <i
i I
4 2
1
Press TAPE.
I o I I <=» I I g I I <=> I I g I
VIOEO/MO TAPE CD TUNER PHONO
Press = to open the cassette compartment,
insert the tape with the side to be piayed
back facing you and cióse the cassette
compartment.
EJECT
10
3 Press DOLBY NR to seiect the DOLBY NR
setting.
DOLBY NR
Press O to start piayback.
o c>
U
When the tape ends, playback automatically stops.
To stop piayback, rewinding or fast forwarding,
press ■.
To pause, press II.
To resume piayback, press II again or D>.
To rewind №e tape, press
To fast-forward the tape, press
Notes
• During playback or recording on a deck, do not operate
the other deck. (When both decks A and B are in playback
mode, only playback from deck A will be audible.)
• Before turning the power off, be sure to stop playback or
recording by pressing ■.
What is the Dolby NR* system?
Dolby NR (noise reduction) system reduces tape hiss noise in
low-level, high-frequency signals. The system boosts these
signals in recording and lowers them in playback.
When listening to a tape recorded with Dolby NR, set the
DOLBY NR switch to ON.
• Dolby noise reduction manufactured under license from Di'lby
Laboratories Licensing Corporation.
"EXDLBV and the double-D symbol CD are trademarks of Dolby
Laboratories Licensing Corporation.