Dolby surround setup, Selecting the impedance (str^e625 only), Locating the speakers – Sony STR-DE625 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Dolby Surround Setup
Selecting the impedance (STR^E625 only)
Set the IMPEDANCE SELECTOR for the front speakers as
indicated in the table below. Check the instruction
manual of your speakers if you're not sure of the
impedгmce. (This information is usually printed on a
label on the back of the speaker.)
If the nominal impedance of
Set IMPEDANCE SELEaOR to
your speaker is
Between 4 and 8 ohms
40
8 ohms or higher
8Q
Note
Be sure to connect the front speakers with nominal impedance of
8 ohms or higher if you want to select both sets of front speakers
(see page 21).
Dolby Pro Logic Surround is a system for decoding
Dolby Surround sound that is standardized for TV
progrtims and movies. By selecting the proper center
mode and adjusting the speaker volume (see page 15),
you can reproduce highly precise localization and
dynamic paiming of sounds of Dolby Pro Logic Surround-
encoded software.
To obtain the best possible surround effect, you will
require at least one additional pair of speakers and /or a
center speaker.
Locating the speakers-'; •
For optimum Dolby Pro Logic Surround sound, locate
your spcaJcers as shown below.
Front speakers
Center speaker
45“ '
X
o
0
3*
<Q
c
•o
01
3
a.
CA
A
2
3
Ifi
c
*0
T
A
tn
•o
A
ai
A
Rear speakers
2V2 to3Vi In,
(60 - 90 mm)
Front speaker