Using the arm band (see fig. m) – Sony SRF-M78 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To prevent accidental change of the receiving station
Press
HOLD, "o-n"
is displayed, indicating that all the functions of the buttons are
locked. To release the key protection, press
HOLD
again.
Preset Tuning
Once you preset the desired stations, you can tune them in by a simple operation. You
can preset up to 5 stations for each of the FM and AM bands.
Presetting the Station
Example:
To set AM 1260 kHz in preset button
2
.
1
Preset
POWER
to turn the radio on.
2
Tune in the station to preset. (See "Manual Tuning".)
3
While holding down
ENTER/CLOCK,
press the appropriate preset button
2
.
The station will be stored and the preset number will appear in the
display.
I If C n I
iC
0
u
I
4/
C n -/
IL U U C
• To change the preset station, set a new station's frequency in the number whose
station you want to change. The pre\'ioiis frequency is canceled.
Tuning in a Preset Station
1
Press
POWER
to turn the radio on.
2
Select the desired band by pressing
BAND.
3
Press the desired preset number button.
The preset number will appar in the display.
4
Adjust
VOL
(volume).
Using the Arm Band (see fig. m)
1
Hold both edges of the connector and slide the connector onto the unit
until you hear a click
2
Unwind and straighten the wraparound band. To more easily straighten
the band, slightly bend the tip of the band in the opposite direction.
3
Hold the body of the unit and attach the straightened band to your arm.
The band will wind by itself,
4
Tighten the band with the rubber belt.
To remove the arm band from the unit (See fig. Q)
Hold both edges of the connector and slide the connector.
To vary the length of the rubber belt to fit your arm (See fig. Q)
Move the velcro fastener to the proper position.
If the rubber belt and wraparound band becomes dirty
Remove the rubber belt from the unit and clean them.
Caution (See fig. B)
* Avoid bending the wraparound band forcibly in the opposite direction. It may break.
• The straightened band will wind easih' when you touch or wiggle it. Be sure to treat it
carefully.