Using the internal center speakers, Rear, Turning the speaker system on and off – Sony SA-VA29 User Manual
Page 9: If you press l/c!) when the speakers are on, Note, Adjusting the contrast of the display window, Getting started
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Using the Internal Center
Speakers
Using the built-in center speakers to enjoy
surround sound without the external center
speaker
The SAVA-29 provides a center speaker in each of the
front speakers, enabling yon to enjoy Dolby Pro Logic
Surround and Dolby Digital (AC-3) sound without the
external center speaker.
The left and right front speakers are equipped with
center channel tweeters (see below) angled at 30° to
reproduce high-frequency center channel sounds.
Low-frequency center channel sounds are mixed with
the front channel signals and reproduced through the
left and right front full range units.
Rear
speakers
Use a screwdriver to remove the screw holding the
CENTER SPEAKER button cover in place. Then
depress the CENTER SPEAKER button. This switches
signal output from the EXTERNAL CENTER
SPEAKER terminal to the internal center speakers.
Turning the Speaker System On
and Off
Press l/(!) on the remote or the front speaker (left).
The front speaker ON(GREEN)/READY indicator
lights green.
Power turns on and off automatically
(Auto power on/off function)
You do not need to turn the speaker system on every
time you use it. Three minutes after the sound source
goes off (when you turn off the TV, or the currently
playing video/laserdisc ends), the speakers turn off
automatically and the ON(GREEN)/READY indicator
turns red.
The speakers turn on by themselves the next time you
turn on the TV or start playback from the VCR.
If you press l/c!) when the speakers are on
The speakers switch to standby mode (the
ON(GREEN)/READY indicator goes off), and the auto
power on/off function turns off. In this case, press l/Cl)
again to turn the speakers on.
Note
The auto power on/off function does not function when 5.1-
channel input is selected.
Adjusting the contrast of the display
window
You can dim the display or turn it off, according to
your preference.
Press DIMMER on the remote a few times until the
display mode you want appears.
The display returns to full brightness.temporarily
when you press one of the buttons on the remote.