2 press—side of editsearch ( c§) ) momentarily, If the picteire has not been recorded, 3 at the desked point, release ewtsearch – Sony CCD-TR7 User Manual
Page 14: 4 press start/stop to start lecordlnb, To stop
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To Check the Last Portion of the
Previous Recording
(F-7)
1 Set the camcorder in the recording pause
mode by pressing START/STOP.
2 Press—side of EDITSEARCH ( c§) )
momentarily.
The Iasi few seconds of the recorded
portion are rewound and then (he tecorded
picture appears in the viewfinder. After a
few seconds of playback, thie camcorder
goes back to the recording pause mode.
if the picteire has not been recorded
The video heads may be contaminated. Clean
the heads using the Sony V6-25CLH video head
cleaning cassette or equivalent.
28
2,3
+ EDITSEARCH — '-
if
1
4
To Re record a Previously Recorded
Portion
1 Slide STANDBY up to set the camcorder to
the standby mode.
2 Look in the viewfinder and lind the point
Irom where you went to begin the recording
by ;
Keeping the + side of EDITSEARCH
pressed to advance the picture at the
normal playback speed, or the - side to
reverse the picture playback.
3 At the desked point, release EWTSEARCH.
4 Press START/STOP to start lecordlnB.
The picture is connected smoothly after the
prerecorded portion even it STANDBY is slid
down and up, or even if the power is turned off
and on again, provided that the tape Is not
removed.
To stop
Slide STANDBY down.
29