Operating a cable box or dss receiver, Cd cd – Sony KV-32XBR100 User Manual
Page 43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operating a cable
box or DSS receiver
You can program the supplied remote commander to
operate a cable box or DSS receiver. Follow the
procedures below to set the manufacturer’s code
number to operate it.
CABLE POWER ■
CABLE FUNCTION
CODE SET ■
~^c£c^\
Œ)
C l '
rpT^
I
■SD CD-o O I
O CD O
©
©
®
®
©
©
©
©
®
q
1®[©
DSS POWER
■ DSS FUNCTION
-TV FUNCTION
- 0-9 buttons
-ENTER
- CH +/-
Turn off the equipment you want to set up
and press the FUNCTION button of the
equipment you want to set up (CABLE or
DSS).
------- FUNCTION--------
CABLE DSS
(ZD (
)
b
Press CODE SET. then press 0 - 9 to enter
the manufacturer's code number (see the
chart below) and press ENTER. For
example, to program your remote
commander to operate a Zenith cable box,
press CODE SET, 2, 1. 2 and ENTER.
CODE SET
ENTER
+ 2 ) -
f
( 1
3
Press CABLE POWER to turn on a cable box
or DSS POWER to turn on a DSS receiver.
------- POWER -----------
CABLE DSS
CD CD
b
4
Use the TV control buttons to check if your
code number works.
For example, to operate a cable box, you can use the
CABLE POWER, JUMP, CH +/-, 0-9 and ENTER
buttons.
To operate a DSS receiver, you can use the DSS
POWER, JUMP, DISPLAY, MENU and 0-9 buttons,
and the joystick.
To operate the TV
Press TV FUNCTION. Then use the TV control buttons
to control the TV.
For more details on operating the cable box or
DSS receiver
Refer to the operating instructions that come with the
equipment.
If the remote commander doesn't work
• First, try repeating the setup procedures using the other codes
listed for your equipment.
• If — after trying all the codes listed for your equipment — you still
cannot get the remote commander to work properly, try the
learning function described on page
44.
Manufacturer code numbers (cable box)
Manufacturer
Code number
Hamlin/Regal
222, 223, 224, 225, 226
Jerrold/G. I.
201, 202, 203, 204, 205, 206, 207, 208,
218
Oak
227, 228, 229
Panasonic
219, 220, 221
Pioneer
214, 215
Scientific Atlanta
209,210,211
Tocom
216, 217
Zenith
212, 213
Manufacturer code numbers (DSS receiver)
Manufacturer
Code number
Sony
801
RCA
802
Notes
• If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
• If you enter a new code number, the code number you previously
entered at that setting is erased.
• In some rare cases, your equipment may use a code that is not
provided with this remote commander and you may not be able to
operate your equipment with the supplied remote commander. In
this case, use the equipment's own remote control unit or use the
learning function (page
44).
• Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code numbers revert to
the factory settings and niList be reset.
Operations
43