Sony CCD-TR400 - Manual (Page 40)

Maintenance Information and Precautions
Precautions
Camcorder Operation
• Operate the camcorder using 6.0 V (battery pack) or 7.5 V (AC power adaptor).
• For DC or AC operation, use only the accessories recommended in this manual.
• Should any solid object or liquid fall into the casing, unplug the camcorder and have it checked by
your nearest Sony dealer before operating it any further.
• Avoid rough handling or mechanical shock. Be particularly careful of the lens.
• Keep the POWER switch set to OFF when not using the camera.
• Do nut wrap up the camcorder and operate it since heat may build up internally.
• Keep the camcorder away from strong magnetic fields or mechanical vibration.
On Handling Tapes
Do not insert anything into the small holes on the rear of the cassette. These holes arc used to sense the
type, thickness of tape, or if the tab is out or in.
Camcorder Care
• When the camcorder is not to be used for a long time, disconnect the power si>urce and remove the
cassette. Periodically turn on the power, operate the camera and player sections and play back a tape
for about 3 minutes.
• Clean the lens with a soft brush to remove dust. If there are fingerprints on the lens, remove them
with a soft cloth.
• Clean the camcorder body with a soft dry cloth, or a soft cloth lightly moistened with a mild
detergent solution. Do not use any type of solvent which may damage the finish.
AC Power Adaptor
Charging
• Use only for the specified battery pack. This unit cannot be used to charge an NP*500 series battery
pack.
• Attach the battery pack firmly.
• Charge the battery pack on a flat surface without vibration.
Others
• The model for USA or Canada: One blade of the plug is wider than the other for the purpose of
safety and will fit into the power outlet only one way. If you are unable to insert the plug fully into
the outlet, contact your dealer.
• Unplug the unit from the wall outlet when not in use for a long time. To disconnect the cord, pull it
out by the plug. Never pull the cord itself.
• Do not operate the unit with a damaged cord or if the unit has been dropped or damaged.
• Do not bend the AC power cord forcibly, or put a heavy object on it. This will damage the cord and
may cause a fire or an electrical shock.
• Be sure that nothing metallic comes into contact with the metal parts of the connevting plate. If this
happens, a short may occur and the unit may be damaged.
• Always keep the metal contacts clean.
• Do not disassemble the unit.
• Do not apply mechanical shock or drop the unit.
• While the unit is in use, particularly during charging, keep it away from AM receivers and vidcH)
equipment because it will disturb AM reception and video operation.
• The unit becomes warm while in use. This is normal.
• Do not place the unit in locations that are:
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Vibrating
I If any difficulty should arise, unplug the unit and contact vour nearest Sonv dealer.