Sony CCD-TR400 - Manual (Page 42)

Trouble Check
If you run into any problem using the camcorder, use the following table to troublesh<.x>t the problem.
Should the difficulty persist, disconnect the power source and contact your Sony dealer or IcKal
authorized Sony service facility.
Camcorder
Symptom Cause Corrective Actions Page
'
The power is not on. The battery pack is not attached. Attach the battery pack. 8
The battery is dead. Use a charged battery pack. 6
The AC power adaptor is not
connected to a wall outlet.
Connect the AC power adaptor
to a wall outlet.
IK
The power goes off. While being operated in
CAMERA mode, the camcorder
has been in the Standby mode
for more than 5 minutes.
Turn STANDBY down once and
turn it up again.
It
The battery is dead. Use a charged battery pack. 6
The battery pack is quickly
discharged. The ambient temperature is too
low.
— 35
The battery pack has not been
charged fully.
Charge the battery pack again.
6
The battery pack is completely
dead, and cannot be recharged.
Use anothc>r battery pack.
36
1
f
START/STOP does not operate. The tape is stuck to the drum. Eject the tape. 9
The tape has run out. Rewind the Upe or use a new
one.
16
The POWER switch is set to
VTR.
SetittuCA.MERA.
10
The tab on the cassette is out
(red).
Use a new tape or slide the tab.
9
The cassette cannot be remox’cd
from the holder.
The battery is dead. Use a chargc*d battery pack or
the AC powc^r adaptor.
6,18
No function except for cassette
ejection works.
Moisture condensation has
occurred.
Remtove the cassc^tte and leave
the camcorder for at least an
hour.
38
The tapi> does not move when a
tape transport button is pressed.
The POWER switch is set to
CAMERA or OFF.
Set it to VTR.
16
The tape has run out. Rewind the tape or use a new
one.
17
The date or time indicator is
flashing.
You pressed DATE and TIME
together for mure than 2
seconds.
The camcorder is not
malfunctioning. You may start
recording. Flashing will stop
soon.
—
The STEADY SHOT function
dues nut activate.
STEADY SHOT is set to OFF. Set STEADY SHOT to 0.\.
25
The auto focusing function does
not activate.
Shooting conditions are nut
suitable for auto focusing
operation.
— -
The FOCUS switch is set to
MANUAL.
Set to AUTO.
22
The lens is dirty. Clean the kms with a dry. soft
cloth.
40