Sony KV-27S10 - Manual (Page 22)

Vìdeo equipment manufacturer code numbers
Manufacturer Code
SONY 01,02,03,04
CANON 05
EMERSON 22,30,33
FISEIER 10,11,12,15
FUNAI 29
GENERAL ELECTRIC 05,08
GOLDSTAR 25
HITACHI 07,08,36
JVC 16,35
MAGNAVOX 05,06,09
MITSUBISHI 18,19,26,27
MULTITECH 29
NEC 16,23,31
PANASONIC 05,06
PHILCO 05,06
PHILIPS 05,06,09
QUASAR 05,06
RCA 07,08
SAMSUNG 24,32
SANYO 11,15
SCOTT 21
SHARP 13,14
SHINTOM 34
SYLVANIA 05,06,09
SYMPHONIC 29
TEKNIKA 28,29
TOSHIBA 20,21
TOTE VISION 25
ZENITH 17
Notes
• If more than one code number is listed, try entering them one
by one, until you come to the correct code for your equipment.
• In some rare cases, you may not be able to operate your non-
Sony video equipment with this remote commander. This is
because your equipment may use a code that is not provided
with this remote commander. In this case, please use the
equipment's own remote control unit.
• The code numbers for Sony equipment are assigned at the
factory as follows;
01
02
03 (preset code for this remote
commader)
04
Beta, ED Beta VCRs
8 mm VCR
VHS VCR
MDP
Caution
When you remove a battery from the remote commander, the
code may revert to 03. Reset the code each time you replace the
battery if necessary.
Operating video equipment
■
KV-27V10I29V11O29V10M only
Video Operating .
buttons
Use the video operating buttons on the remote
commander to operate the video equipment.
Operating a VCR Buttons on the remote
commander
To turn on or off Press VIDEO POWER
To change channels Press CH +/-
To record Press • and REC
simultaneously
To play Press ►
To stop Press ■
To fast forward Press ►►
To rewind the tape Press ◄◄
To pause Press II
To search the picture
forward and backward
Press ►► or ◄◄ during
playback
Operating the Laser-disc
player Buttons on the remote
commander
To play Press ►
To stop Press ■
To pause Press II
To resiune normal playback,
press again.
To search the picture
forward and backward
Keep pressing ►► or
during playback
To resume normal playback,
release the button.
To search the chapter
forward and backward
Press CH +/-
Note
• If the video equipment does not have a certain function, the
corresponding button on this remote commander will not
operate.
22 Operations