CDA SC309 - Manual (Page 5)

✓ The power supply cord must not touch against any hot surfaces and must be placed
so that its temperature does not exceed 75°C at any point along its length.
✓ After having installed the appliance, the power switch or power plug must always be
in a accessible position.
✓ The appliance must have its own supply; any other appliances installed near it must be
supplied separately.
✓ N.B. For connections to the mains power supply, never use adaptors, reductions or
multiple power points as these may overheat and catch fire.
✓ In the event that installation should require modifications to the mains supply wiring
system or if the power plug is not suitable for the type of power point available, it is
recommended that a qualified technician be called to carry out substitution. The tech-
nician will also have to verify that the cross-section of the electric cables on the power
point match the appliance’s power rating.
✓ If the supply cord is damaged, it must be replaced by a special cord by a qualified elec-
trical technician in order to avoid a hazard.
GENERAL NOTES
✓ The wires in the mains lead on this appliance are coloured in accordance with the
following code:
Green and Yellow - Earth
Blue – Neutral
Brown – Live
✓ As the colours may not correspond with the markings identifying the terminals in
your plug or in your spur box, proceed as follows:
➜ The green and yellow wire must be connected to the terminal which is marked
with the letter E or with the earth symbol or coloured green and yellow.
➜ The blue wire must be connected to the terminal marked N or coloured black.
➜ The brown wire must be connected to the terminal marked L or coloured red.
FEEDER SPECIAL CABLE SECTION
Type “HO5RR-F”
230 VAC 50 Hz 3 x 0,75 mm 2
✓ The supply cable must be replaced with a cable of
the same type.
✓ The electrical cable must be connected to the
terminal board following the diagrams of Fig. 3.
230 V
L1 N(L 2 )
PE
Figure 3
5